Optional Blower / Fan Installation - HAMPTON BAY Hampton H300 Owners & Installation Manual

An optional blower is available for the Hampton
H300. The blower is factory assembled, wired
and ready for attachment to the stove.
This unit must be connected to a grounded,
standard 120 volts, 60 Hz electrical outlet.
Never route the power cord under or in front
of the unit.
Do not under any circumstances, cut or remove
the grounding prong from the power cord. Do
not use an adaptor plug.
NOTE: For more detailed information see
instructions included with the Optional
Blower.
CAUTION: Moving parts may cause injury.
Do not operate unit with blower housing
removed.
DANGER: Risk of electric shock. Discon-
nect power before servicing unit.
WARNING: Electrical Grounding
Instructions
This appliance is equipped with
a three pronged (grounding) plug
for your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle. Do not cut
or remove the grounding prong
from this plug.
Neutral
Live
120 AC
60 Hz
Fan Thermodisc
normallyopen
NOTE INPUT POWER: Australia, New Zealand,
China and Japan use 240V AC 50 Hz.
Hampton H300 Cast Freestanding Woodstove

OPTIONAL BLOWER / FAN INSTALLATION

1) Lift off top.
2) Place left and right side air channels on
fi rebox top as shown below.
3) Secure each air channel with one screw.
Right Side
Air Channel
Shown
4) Remove back shield by undoing 2 screws.
anual
reen
round
Auto
Switch
lack
lack
Blower/Fan Wiring Diagram
Screws
Left Side
Right Side
Air Channel
Air Channel
Secure
with screw.
Fan
Switch
lack
Fan Fan
INSTALLATION
5) Remove fan cover plate from back shield
by undoing 3 screws.
6) Loosen the 2 bolts you see after removing
the fan cover plate. One on each side of
unit.
7) Hook fan over bolts.
8) Tighten bolts to secure fan.
9) Reinstall back shield.
10) Using the 3 screws from the fan cover
plate, secure the fan assembly to the back
shield.
11) Plug-in power cord.
12) Place top back on.
CAUTION: Label all wires
prior to disconnection
when servicing controls.
Wiring errors can cause
improper and dangerous
operation.
round
Right Side
Bolt
21