Optional Blower/Fan Installation - HAMPTON BAY Hampton H200 Owners & Installation Manual

An optional blower is available for the Hampton
H200. The blower is factory assembled, wired
and ready for attachment to the stove.
This unit must be connected to a grounded,
standard 120 volts, 60 Hz electrical outlet.
Never route the power cord under or in front
of the unit.
Do not under any circumstances, cut or remove
the grounding prong from the power cord. Do
not use an adaptor plug.
NOTE: For more detailed information see
instructions included with the Optional
Blower.
CAUTION: Moving parts may cause injury.
Do not operate unit with blower housing
removed.
DANGER: Risk of electric shock. Discon-
nect power before servicing unit.
WARNING: Electrical Grounding
Instructions
This appliance is equipped with
a three pronged (grounding) plug
for your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle. Do not cut
or remove the grounding prong
from this plug.
Neutral
ive
120 AC
60 Hz
Fan Thermodisc
normallyopen
NOTE INPUT POWER: Australia, New Zealand,
China and Japan use 240V AC 50 Hz.
Hampton H200 Cast Freestanding Woodstove
1) Remove fan cover plate from back shield
by undoing 3 screws and discard plate.
2) Remove back shield by undoing 2 bolts.
3) Loosen the 2 bolts you see after remov-
ing back shield, one on each side of the
stove.
anual
reen
round
Auto
witch
lac
lac
Blower/Fan Wiring Diagram

OPTIONAL BLOWER/FAN INSTALLATION

Fan
witch
lac
Fan Fan
round
INSTALLATION
4) Hook fan over the bolts.
5) Tighten bolts to secure fan.
6) Re-install back shield.
Back
Shield
7) Using the 3 screws from the fan cover
plate, secure the fan assembly to the back
shield.
8) Plug in power cord.
CAUTION: Label all wires
prior to disconnection
when servicing controls.
Wiring errors can cause
improper and dangerous
operation.
Fan
Tighten
bolts
19