Unpacking And Examining Your Oven - Dacor PMOR3021B Use & Care Instructions Manual

Open the bottom of the carton, bend the carton flaps back and tilt the oven over to
rest on plasticfoam pad. Lift carton off oven and remove att packing materials,
WALL and TOP CABINET TEMPLATES. SAVE THE CARTON AS IT MAY MAKE
INSTALLATION EASIER.
1. Remove the feature sticker from the outside of the door, if there is one.
2. Check to see that there is a WALL TEMPLATE and TOP CABINET TEMPLATE.
Read enc!osures and SAVE the Operation Manual.
Check the oven for any damage, such as misaligned or bent door, damaged door
seals and sealing surfaces, broken or loose door hinges and latches and dents
inside the cavity or on the door. If there is any damage, do not operate the oven
and contact your dealer or DACOR AUTHORIZED SERVICER. See Installation
Instructions for more details.
Safety door Door seals and
latches sealing surfaces
INSTAILLATiON i NS'II'F_UC'II'i{_NS
Please read all instractiensthoroughly before installing the Over the Range lV]icrewave0yen/Need
System. Tw0 people are recommended te install this product.
if a new emectrieam outlet is required, its inatammatien should be completed by a qualified electrician
before the J'_icrewave 0yen/Need is instammed. See 3 ELECTRICALGROUNDJNG iNSTRUCTiONS en
page 7.
1 MOUNTING SPACE
This Microwave Oven/Hood requires a mounting space
on a wail as shown in Figure 1. It is designed to be used
with standard 12=inch wall cabinets.
There needs to be least 2 inches from the top of the
range backsplash to the bottom of the over the range.
2 WALLCONSTRUCTION
This Microwave Oven/Hood should be mounted against
and supported by a flat vertical wall. The wall must be
flat for proper installation. If the wall is not flat, use spac-
ers to fill in the gaps. Wal! construction should be a mini°
mum of 2" x 4" wood studding and 3/8" or more thick dry
wall or plaster/lath. The mounting surfaces must be ca=
pable of supporting weight of 110 pounds--the oven and
contents=AND the weight of all items which would nor=
molly be stored in the top cabinet above the unit.
Figure 1
Epicoreand
Preference range =
coekingsarface
The unit should be attached to a minimum of one 2" x 4" wall stud.
To find the location of the studs, one of the following methods may be used:
A. Use a stud finder, a magnetic device which locates the nails in the stud.
B. Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate stud location.
The center of the stud can be located by probing the wall with a small nail to find the edges of the stud and then
placing a mark halfway between the edges. The center of any adiacent studs will normaUy be 16" or 24" to either
side of this mark.