Dacor PMOR3021B Use & Care Instructions Manual page 12

UNPACKING AND INSTALLATION INSTRUCTIONS
9 OVEN INSTALLATION
TH1S OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCo
TIONS FOUND ON WALL AND TOP CABINET TEMPLATES,
THE NEXT STEP IS TO READ AND FOLLOW MOUNTING INFORMATION ON WALL AND TOP CABINET
TEMPLATES. THIS OVEN MUST BE ATTACHED TO AT LEAST ONE WALL STUD. SEE WALL CONSTRUC-
TION ON PAGE 6.
WHEN DONE WITH TEMPLATES, PROCEED TO MOUNTING SCALE PLATE SECTION.
MOUNTING SCALE PLATE SPACERS
Attach 2 Scale Plates _ with tape (not included), See Figure 16 and WALL TEMPLATE for locations.
Figure 16
Scale Plates J
o o o o o
o o o o o o o o
[Vloantin§ Plate
°oo°oo
MOUNTING PLATE
1. Separate 4 Toggle Bolts _, packed in the INSTALLATION HARDWARE, from the Toggle Nuts.
2. Match 5/8" holes (not in studs), drilled through WALL TEMPLATE into wal! to corresponding holes on Mounting
Plate.
3. insert Toggle Bolts into matched openings on Mounting Plate, Put Toggle Nuts on Toggle Bolts, See Figure 17.
4. Position the Mounting Plate with the Toggle Bolts attached at the wal! location and insert Toggle Nuts and Bolts
through the holes in the wall with the Toggle Nuts closed, Figure 18, Use Wood Screws (_ to attach the Mount°
ing Plate to studs.
NOTE: Before insertion, be sure you leave a space more than the thickness of the wal! between the Mounting
Plate and the end of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the
Toggle Nut wil! not be able to open on the other side of the wall, Also, once a Toggle Nut opens, it cannot be
withdrawn from the hole; therefore make sure aH of the Toggles are in the correct position before
insertion,
5. Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts, Pull Toggle Bolt toward you
and turn clockwise to tighten, Figure 19.
6. Remove scale plates,
Figure 17 Figure 18
[V]ounti
Plate
_ pace morethan
wall thickness
\ Wall
12