Dacor PMOR3021B Use & Care Instructions Manual page 10

8 VENT&ATION SYSTEM (PREPARINGOVEN FOR INSTALLATION}
This Microwave Oven/Hood isdesigned for adaptation to three types of hood ventilation systems, Select the type
required foryour installation.
Recirculating -- non-vented, ductless. Follow installation procedure (A), Recirculating requires the use of the
Charcoal Filter, which has already been installed in the oven,
Horizontal Exhaust -- outside ventilation. Fo!low installation procedure (B),
Vertical Exhaust -- outside ventilation, Follow installation procedure (C),
(A) RECIRCULATING: Non-Vented, Ductless Operation
The unit is shipped assembled for recirculating.
NOTE: 1. The Exhaust Damper Assembly @ is not required for recirculating operation,
2. The Charcoal Filter should be replaced every 6 to 12 months, depending on use,
(B) HORIZONTAL EXHAUST: OUTSIDE VENTILATION
1. Remove 2 screws from back edge and 3 screws from the top center of Fan Cover BrackeL Save 2 screws to be
used later and discard remaining 3. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow
on the Fan Cover Bracket, as shown in Figure 7.
2. Lift Hood Fan Unit carefully and slip wires out of cavity. See Figure 8. CAUTION: Do not pull or stretch hood fan
wiring.
3. Rotate the Hood Fan Unit 180 so that the fan blade openings are facing the back of the oven. See Figure 9 (A).
Replace Hood Fan Unit into the oven. Be careful not to pinch the wire and the Hood Fan Unit. See Figure 9 (B).
4. Put the wire back into the cavity. See Figure 10.
Figure 7
I
(A) Rotate 180_
Figure 9 Figure 10
I
Save fan cover bracket for
future instructions,
10