—
setNetworkCardSubnetMask ethX X.X.X.X (first parameter is the port
designation and second parameter is the subnet mask).
—
setNetworkCardGatewayAddress ethX X.X.X.X (first parameter is
the port designation and second parameter is the gateway address).
Enslave the first port to the bond. The bond will then assume the IP
I
configuration of the first port enslaved.
—
bondEnslaveNetworkCard ethX bondY (first parameter is the port
being enslaved into the bond that is designated by the second
parameter).
Enslave the second port to the bond.
I
—
bondEnslaveNetworkCard ethY bondY (first parameter is the port
being enslaved into the bond that is designated by the second
parameter).
To un-bond the ports take the following steps:
bondReleaseNetworkCard ethY bondY (first parameter is the port being
I
un-bonded from the bond that is designated by the second parameter).
Note
The ports are being un-bonded in the reverse order that they
were enslaved.
bondReleaseNetworkCard ethX bondY (first parameter is the port being
I
un-bonded from the bond that is designated by the second parameter)
Reboot the NAS server.
I
Configuring Your System and Network
57