Operation; To Charge; Installing Screwdriver Bits - Craftsman evolv 320.17088 Operator's Manual

For low light situations.
POWER UNIT
After the initial charging cycle, the tool should be charged for 3-5 hours for
optimum performance.
TO CHARGE (FIG. 2)
Make sure your screwdriver has completely stopped before attempting to
charge it.
Insert the power unit plug into
charging socket, making sure
they are properly connected.
Power unit can be used with
normal house voltage of 120
volts, 60 Hz, AC only.
Connect the power unit to the
power supply.
Fig. 2
Forward/
Reverse
Switch
On/Off Trigg_
Switch
Once the screwdriver is initially
charged for at least 10 hours, Bit Collet
optimum performance can
be reached by recharging the LED worklight
screwdriver for 3-5 hours after
use. It is not recommended to
recharge the screwdriver for less than 3 hours or more than 15 hours after each
use.
Do not place the power unit in an area of extreme heat or cold. It works best at
normal room temperature.
The base of tool or power unit
may become warm during
charging.
iNSTALLiNG SCREWDRIVER
BiTS (Fig.3)
Place a 1/4" bit directly into the
screwdriver collet, or, insert it
into the magnetic bit holder and
then insert the bit holder into
the screwdriver collet.
Fig. 3
Note: Your screwdriver is
intended for light=duty use.
17088 Manual Revised 09-0728 Page 12