Operation; Maintenance - Craftsman 315.101650 Operator's Manual

A
A
A
WARNING: When servicing, use only identical
Craftsman replacement parts. Use of any other part
may create a hazard or cause product damage.
WARNING: Always wear safety goggles or safety
glasses with side shields when using compressed air
to clean tools. If the operation is dusty, also wear a
dust mask.
WARNING: To avoid serious personal injury, always
remove the battery pack from the tool when cleaning
or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
_IL WARNING: Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating oils,
etc., come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which may
result in serious personal injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at a Sears Service Center.
BATTERY PACK REMOVAL AND PREPARATION
FOR RECYCLING
See Figure 5.
TO REMOVE:
m Remove the three screws securing motor housing cover
then remove cover.
m Lift batteries from motor housing enough to expose
leads and battery terminals. Disconnect leads from
battery terminals. NOTE: Be careful not to break battery
leads when disconnecting them.
__Ni_c _ To preserve natural resources, please
recycle or dispose of batteries properly.
=
This product contains nickel-cadmium
batteries. Local, state or federal
laws may prohibit disposal of nickel-
cadmium batteries in ordinary trash.
Consult a local waste authority for information regarding
available recycling and/or disposal options.
A
WARNING: Upon removal, cover the battery pack's
terminals with heavy-duty adhesive tape. Do not
attempt to destroy or disassemble battery pack or
remove any of its components. Nickel-cadmium
batteries must be recycled or disposed of properly.
Also, never touch both terminals with metal objects
and/or body parts as short circuit may result. Keep
away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
BATTERIES
The screwdriver is equipped with 4 nickel-cadmium
rechargeable batteries. Length of service from each
charging will depend on the type of work you are doing.
The batteries in this tool have been designed to provide
maximum trouble free life. However, like all batteries, they
will eventually wear out. To remove and dispose batteries,
follow BATTERY REMOVAL instructions. Handling of these
batteries, especially when wearing rings and jewelry, could
result in a serious burn.
To obtain the longest possible battery life, we suggest the
following:
m Remove the tool from the charger once it is fully
charged and ready for use.
For battery pack storage longer than 30 days:
m Store the battery pack where the temperature is below
80°F.
m Store battery packs in a "discharged" condition.
SCREW(S)
BATTERIES
_ COVER
SCREW
BATTERY LEADS
I
L_ BATTERY
TERMINAL
I
I
I
BATTERY
TERMINAL
MOTOR
HOUSING
SCREW(S)
GEARHOUSING
Fig. 5
11