Maintenance - Craftsman evolv 320.17088 Operator's Manual

For best results, 1/4" screwdriver bits are recommended.
Never engage the trigger switch when changing screwdriver bits.
Always lock the trigger switch when changing drill bits. (See forward/reverse
switch instructions)
FORWARD/REVERSE SWITCH (Fig.4)
The forward/reverse switch determines the running direction of the tool and also
serves as a trigger switch lock.
To select "forward" motion,
release the trigger switch and
push the forward/reverse lever
to the right side of the tool.
To select "reverse" motion,
push the forward/reverse lever
to the left side of the tool.
The center position of the
switch locks the tool in the
"OFF" position.
Fig. 4 FORWARD REVERSE
When changing the position of
the switch, be sure the trigger SWITCH LOCKED IN CENTER POSITION
is released.
,_ WARNING: Charging time must not exceed 15 hours; the battery may be
damaged with excessive charging. Avoid charging your screwdriver in freezing
conditions. The power unit provided must only be used with this screwdriver
and not with any other products. Do not insert metal objects into the power unit.
Never change the forward/reverse switch while the screwdriver is rotating as this
will damage the screwdriver.
,_ WARNING: To ensure safety and reliability, all repairs should be performed
by a qualified service technician at a Sears Service Center.
,_ WARNING: For your safety, always turn off the switch and remove the
battery pack from the tool before performing any maintenance or cleaning.
Periodic maintenance of your screwdriver allows for long life and trouible-free
operation. A cleaning, and maintenance schedule should be maintained.
As a common-sense and preventive maintenance practice, follow these
recommended steps:
• Inspect the bit; check the rim for wear or damage.
• Use a soft clean and damp cloth to wipe the tool housing. A mild detergent
17088 Manual Revised 09-0728 Page 13