Operation - Craftsman 320.37810 Operator's Manual

HOW TO CHARGE THE
SCREWDRIVER (Fig. 2)
To protect your new rechargeable
screwdriver from possible damage,
the battery is in a low-charge
condition when initially shipped.
Insert the power unit jack into
the charging socket, making sure
that it is properly connected.
The power unit can be used with
normal household current: 120
volts, 60 Hz, AC only. Connect the
power unit plug to an electrical outlet.
The indicator light on the screwdriver initially shines red when the power unit is
plugged into a power source and will shine green when the battery is fully charged.
Charge the battery for at least 7 hours before the first use.
NOTICE: For best results, do not recharge the battery for less than 5 hours or
more than 7 hours after each use.
Do not place the power unit in an area of extreme heat or cold. It works best at
normal room temperature. The screwdriver or power unit may become warm
during charging. This is normal.
INSERTING AND REMOVING
SCREWDRIVER BITS (Fig. 3 )
Inserting the bit
Place the bit directly into the
screwdriver collet; the wire
retainer inside the collet holds the
bit in place.
NOTICE: Your screwdriver is
intended for light-duty use. For best
results, 1⁄4 in. hex screwdriver bits
are recommended.
Removing the bit
Pull the bit forcibly to remove it from the tool.
ѥ
WARNING: Always set the lock-off slide to the locked position (
inserting or removing the bit.
37810 Manual_Revised_13-0116

OPERATION

Fig. 2
Charging
socket
Fig. 3
Power unit
jack
Charging
indicator
) , when
Page 13