INSTALLING
THE TABLE
!
Loosen support lock and ra=se table support 10y
tumRngtable crank clockwise unbl support =s at a
working height level. Tighten support lock.
TABLE
SUPPORT
f
TABLE
RACK
TABLE
SUPPORT
,
Remove protective covering from table and dis-
card. Place table in table support and tighten table
lock (located under table) by hand.
TABLE
LOCK
ii
!
TABLE
INSTALLING
THE HEAD
CAUTION:
The head assembly
weighs
about 55
pounds. Carefully
lift head.
1. Remove protective bag from head assembly and
discard. Carefully lift head above column tube and
slide it onto column making sure head slides down
over column as far as possible. Align head with
table and base.
HEAD
COLUMN
HEAD
LOCK
2. Using a 5mm Hex "L"wrenchtighten the two head
lock set screws on the right side of the head.
SCREWS
=-
_'r
__=
LD
11