Motor Connections; Installing Feed Handles; Installing The Chuck - Craftsman 113.213170 Owner's Manual

MOTOR CONNECTIONS
WARNING: FOR YOUR OWN SAFETY, NEVER CON-
NECT PLUG TO POWER SOURCE OUTLET UNTIL
ALL ASSEMBLY STEPS ARE COMPLETED,
t. Open motor connector box cover located on under-
side of motor using a flat blade screwdriver.
WARNING: TO AVOID ELECTROCUTION, NEVER
CONNECT ANYTHING BUT THE GROUND WIRE
{COLORED GREEN) TO THE GREEN SCREW.
2. Remove GREEN SCREWand insertthrough round
metal terminal on the end of the GREEN wire of
power cord.
3. Reinsert GREEN SCREW in threaded hole that it
was removed from and tighten securely.
4. Insert terminal end of WHITE wire on spade termi-
nal (next to silver post) marked #4 on the motor,
Push terminal firmly until seated.
5. Insert terminal end of BLACK wire on spade termi-
nal (next to copper post) marked #1 on the motor.
Push terminal firmly until seated,
6, Close motor connector box being sure that power
cord is seated in strain relief groove and tighten
box cover screws.
7. Do not plug in power cable.
BLACK WIRE TO
TERMINAL #1
COPPER POST
GREEN WIRE
TO GREEN SCREW
STRAIN RELIEF
GROOVE
WHITE WIRE
TO TERMINAL #4
SILVER POST
laO_0R
GREEN
IGROUNO)
INSTALLING FEED HANDLES.
1. Locate three (3) feed handles among loose.parts.
2. Screw the feed handles into the threaded holes in
the hub and tighten.
HUB
FEED
HANOLE
INSTALLING THE CHUCK
1. Clean out the TAPERED HOLE in the chuck. Clean
both tapered surfaces on the arbor with a clean
cloth. Make sure there are no foreign particles stick-
ing to the surfaces. The slightest piece of dirt on
any of these surfaces will prevent the chuck from
seating properly. This will cause the drill to
"wobble."
14
\
NOLE
_j ARBOR
CLEAN THIS
SURFACE