Table of Contents
Advertisement
INSTALLING
LIGHT
BULB
1. Install a light bulb (not larger than 60 watt) into the
socket inside the head.
ADJUSTING
THE TABLE
SQUARE
TO HEAD
NOTE: The combination square must be "true." See
"Unpacking
and
Checking
Contents"
section
for
method.
1. Insert a precision ground steel rod approximately
3" long into chuck and tighten.
2. With table raised to working height and locked on
column, place combination square flat on table be-
side rod.
3. If an adjustment is necessary, loosen the set screw
under bevel lock with 3ram Hex "L" wrench, then
loosen the table bevel lock with a 15116" wrench.
(These adjustments
are located under the table).
4. Align the table square to the rod by rotating the
table until the square and rod are in line.
5. Retighten
table bevel lock.
6. Retighten
set screw.
SCREW
BEVEL
LOCK
BEVEL
SCALE
NOTE: The bevel scale has been included to provide
a quick method for beveling the table to approximate
angles. If precise accuracy is necessary, a square, or
other precision measuring tool should be used to posi-
tion the table.
1, To use the bevel scale do the following:
a. Loosen set screwand table bevel lock (see step
3 above).
b. Move table so desired angle or bevel scale is
straightacrossfrom zerolineon table support.
c. Retighten table bevel lock and set screw.
POINTER
SCALE
TABLE
|
TABLE
16
Hide quick links:
Advertisement
Table of Contents
