Resetting The Lamp Usage Timer; Checking The Projector Status - Epson PowerLite Cinema 500 User Manual

8. Replace the cover and tighten its screws. (The projector won't work if the lamp cover is
open or loose.)
9. Reset the lamp usage timer, as described in the next section.

Resetting the Lamp Usage Timer

After replacing the lamp, follow these steps to reset the lamp usage timer:
1. Press the
2. Use the menu navigation buttons to open the
.
Reset
3. When you see a confirmation prompt, highlight
4. When you're finished, press the
The lamp usage timer doesn't register until you've used the lamp for at least 10 hours.

Checking the Projector Status

You can use the Info menu to view information about the current display settings and how
long the projection lamp has been in use. To access the Info menu:
1. Press the
2. Use the menu navigation buttons to open the
appears:
Lamp Hours
Source
Input Signal
Resolution
Note: The information displayed depends on the currently selected image source.
The Lamp Hours shows 0H until you've used the lamp for at least 10 hours.
The resolution indicates the total number of scan lines in the source signal; the
number of visible scan lines depends on the signal format standard and selected
display settings (see page 70).
58
Checking the Projector Status
button on the projector or remote control.
Menu
button on the projector or remote control.
Menu
menu, then select
Reset
Yes
button to exit.
Menu
menu. The following information
Info
Video Signal
Refresh Rate
Sync Info
Lamp-Hours
and press the button.