Connectivity
Use these settings to set up the projector when you connect a PC or laptop for running
Cinema Color Editor (see page 41).
COM Port
Setting ! Operation ! COM Port
Select the type of cable you've connected to your PC or laptop. Choose
(for a serial cable).
Network
Setting ! Operation ! Network
Use these settings to configure your projector if you've connected it to a network. Select
if your network assigns addresses automatically through a DHCP router or server;
DHCP
otherwise enter the projector's IP address using the arrow buttons on the remote control.
Press the
so the new settings take effect.
Note: SNMP trap IP addresses are not used in home environments. If the projector is being set
up on a large-scale business network, consult your IS department for assistance.
Network Monitoring
Setting ! Operation ! Network Monitoring
If you've connected the projector to a network and you want to be able to turn it on
remotely using Cinema Color Editor, switch this setting to
conserve power when the projector is in standby mode.
Note: If Network Monitoring is turned on, the cooling fan will continue to operate after the
projector is turned off. This is normal.
Other Setup Options
Keystone
Setting ! Screen ! Zoom Caption
Adjusts the shape of the image, if the left and right sides are not parallel after tilting the
projector up or down at the screen (see page 20).
Projection
Setting ! Screen ! Projection
Mirrors and/or inverts the image for front, rear, and overhead projection.
38
Customizing Projector Features
button to confirm the new address, then turn the projector off and back on
or
USB
RS-232C
. Otherwise, leave it off to
On