Color Settings - Epson PowerLite Cinema 500 User Manual

Color Settings

If the image colors don't look correct, you can adjust them using these settings. Use the first
three settings described below to make the most visible changes. If you only need to make
slight adjustments, you can fine-tune the picture with the remaining settings.
Note: You can also make color adjustments by attaching a PC or laptop to the projector and using
the Cinema Color Editor software. See page 41.
Color Intensity
Image ! Picture Quality ! Color Intensity
Adjusts the color saturation of the image (not available for computer images).
Tint
Image ! Picture Quality ! Tint
Shifts the color balance between magenta and green (not available for computer images).
Abs. Color Temp.
Image ! Color Adjustment ! Abs. Color Temp. ! Abs. Color Temp.
Shifts the color balance between red and blue, making the image appear warmer or
cooler.
Note: You can display a test pattern to facilitate adjustment. Press the Pattern button on the
remote control, then select Gray scale. Then press the
open an on-screen "line menu" and access the Abs. Color Temp. setting.
Flesh Tone
Image ! Color Adjustment ! Abs. Color Temp. ! Flesh Tone
Makes fine adjustments to the tint. Controls the amount of magenta or green in the
image. Also useful for correcting black-and-white images, if they look tinted.
Note: You can also access the Flesh Tone setting by pressing the
control to open an on-screen "line menu."
RGB
Image ! Color Adjustment ! RGB/RGBCMY ! RGB
Note: If you cannot access the RGB settings, highlight RGB/RGBCMY (the first item in the
menu list) and press the
Use the RGB settings to fine-tune the color of the image. You can adjust the offset,
gamma, and gain for each signal color (red, green, and blue). Use
shades,
Gamma
32
Adjusting the Image Quality
button, then choose RGB in the sub-menu.
for intermediate shades, and
button on the remote control to
button on the remote
Offset
for the lightest shades.
Gain
to adjust darker