Table of Contents
Advertisement
X er o x N u v er a P a p er G u id e
over. If the problem persists, try replacing the paper in the tray
with fresh paper.
•
If misfeeds or multifeeds occur, open the paper tray and
remove partially fed sheets. Adjust the paper stack so it is
uniform and is positioned tightly against the lead (left) edge of
the tray. Position the paper guides against the stack to secure
it.
•
If multifeeds occur during printing, leave the paper in the tray
and fan the top of the stack.
–
Hold one side of the stack with one hand to prevent it from
moving.
–
Gently lift the top four inches (10 centimeters) of the
opposite side of the stack, then allow the sheets to gently
fan back down into the tray.
Figure 2-5. Fanning the lead edge
•
A special tabs guide must be installed on the trail edge paper
guide before tabs can be loaded and run from a paper tray.
There are two tabs guides: one is labeled A4/11" (can be put in
any tray) and the other is A5/5.5" (can be put in trays 1 and 2).
These tab guides are mounted on brackets or in a molded
pocket that is located inside the Feed Module front door. See
the instructions for installing tab guides that were included in
the tabs guide kit for more information.
–
When the tabs guide is installed in a paper tray, only
tabbed stock that corresponds to the tab guide (i.e. 9"x11"
tabs with the 11" guide) should be run from the tray.
–
When loading a tray with a tabs guide, do the following to
prevent damage to the trail edge paper guide:
Move the outboard paper guide away from the stack
before moving the trail edge guide away from the
stack.
Position the trail edge paper guide against the stack
Ma n ag i ng y ou r pa pe r s u pp l y
2-9
Advertisement
Table of Contents
