To Lower Extension; Leveling Extensions; To Lower Outer Edge Of Extension; To Raise Outer Edge Of Extension - Craftsman 113.221611 Owner's Manual

TO LOWER EXTENSION
!. If extension is too high loosen four screws on
underside of the extension D, E, F, and G. See
illustration.
2 Tighten screws A, B and C on top of table
extension to lower extension even with table top
front and rear.
3. Check height with square and tighten screws D,
E, F and G
4. Repeat for left extension.
,,,u,
EXTENSfON
LEVELING EXTENSIONS
Place combination square on table and extension so
that end of blade extends over edge of extension.
HoLd square firmly on saw table and check for gap
between extension and blade of square.
SHOULD BE
NO GAP
TO LOWER OUTER EDGE OF EXTENSION
1. Loosen screws B_ E, and Fon right extension. See
ilhJstration
2 Tighten screws C, D, and G until table extension
is Level
3o Snug down screws B, E, and Fr.
4 Repeat for left extension
EXTENSION
TO RAISE OUTER EDGE OF EXTENSION
1 Loosen screws C, D, and G on right extension.
2. Tighten screws B, E, and F until table extension is
tevet
3. Snug down screws C, D, and G
4. Repeat for left table extension.
1
EXTENSION
14