Aligning Spreader - Craftsman 113.221611 Owner's Manual

6 Laya pieceof flat straightwoodandasquare on
sawtableandrotatethe SPREADER S UPPORT
until the bracketis alignedwith square
7 MAKE SURE END OF SUPPORT, B RACKET
ANDRODAREEVEN.,+usingan1/8in+HexL
wrench,TIGHTEN THESETSCREWS ONLY,
ENDS OF SUPPORT
AND BRACKET TO
BE EVEN WITH
END OF ROD
TIGHTEN
SETSCREW ONLY
ALIGNING SPREADER
IMPORTANT: The SPREADER must always be
PARALLEL to the sawblade and in the MIDDLE of
the cut (KERF) made by the sawblade.
NOTE: The spreader is thinner than the width of the
KERF by approximately six thicknesses of paper
SPACE EQUAL TO APPROX
3 THICKNESSES OF PAPER KERF WOOD
.... :_ o/ J
/
SPREADER
SPACE EQUAL TOAPPROX, LOOKING DOWN ON SAW
3 THICKNESSES OF PAPER
1 Make two folds in a small piece (6 x 6 in,,) of
ordinary NEWSPAPER making three
thicknesses The folded paper witl be used as a
"spacing gauge"
17