/'1",CAUTION!
The blade guide supports the blade when cutting and must at all times
I
rest against the back edge of the blade except when in the scrollingmode. It should rotate
I
free y.
TURN POWER "ON-OFF" WHEN USING
AS A BARREL GRIP SABRE SAW (Fig. 3)
1. Connect the power cord of your saw to a
standard householdpower outlet.
2, Turn your saw 'ON' bysliding the "ON-OFF"
switchforward until it 'clicks' into the start
position (Fig. 3).
3.To turn power "OFF", press in on the rear
section of the "ON-OFF" switch to stop
the tool.
Fig. 4
Fig. S
Metal
top
ATTACHING TOP HANDLE ONTO SABRE SAW (Figs. 4, 5)
Remove the "tophandle attaching plate"from the rear top of the barrel (Fig. 4)
by sliding the "plate" completely off the saw's motor housing in the directionof the arrow.
Guide the metal attaching plate located in the inside front of the "top" handle toward the slot
located in the front of the sabre saw just beneath the scrolling knob (Fig. 5). At the
same time, align and slide the rear bottom of the "top" handle into the attaching compartment
which had been covered by the attaching plate (Fig. 4) that you removed earlier. When
sliding the "top" handle onto the attaching plate compartment, hold down the handle-release
buttons until "top" handle snaps and locks into place (Fig. 5),
11