Use In Router Table; Feeding The Workpiece On A Router Table; Top View - Craftsman 130.26620 Operator's Manual

USE IN ROUTER TABLE
Your router can also be used in a router table.
The fixed base is dasigned to allow easy depth
adjustment in a table. The plunge base is not
recommended for use in a router table because
it may cause damage to the plunge router base.
To install the fixed base in a table (sea Fig. 20),
simply remove the sub-base and attach the base
using three #10-32 fiat head machine screws
(not included). The length will depend on the
thickness of your router table or router table
mounting plate. Follow the ddlllng and ir_tallatlon
instructions that were Included with the router
table. In order to use the over table adjustment
feature on your router, you will also need to ddll
a hole in the router table or mounting plate to
allow access to the fine depth adjustment rod.
The depth can be adjusted over a 7/8-in. range
from above the table using the over-table
adjustment wrench (included).
When installinga router bit be sure that the
coarse adjustment level is near the lowest
point of the depth Indicator ring.
Also be sure the muter bit is installed at the
proper height for the cut to be made,
(the height of the first cut, ff multiple passes
are going to be made).
ALWAYS re-clamp the motor in the base
BEFORE turning on the motor and routing.
For complete instructions on the operation
of a muter in a router table, refer to the
instructions that come with the router table.
FEEDING THE WORKPIECE
ON A ROUTER TABLE
Always use your router table's fence or starter
pin and the appropriate guard end follow the
router table's instruction manual. ALWAYS feed
the workpiece from right to left across the front
of the bit.
Whenever possible, when usingthe fence, use
a push stick to push the workpleoe, especially
when working with narrow plecas.
WORKPIEGE
BEARIN6
TOPVIEW
NOTE: For clarity, guard and featherboard
removed from drawing.
-19-