Table of Contents
Advertisement
TO A'n'ACH TEMPLATE GUIDE
BUSHINGS TO ROUTER
1. DISCONNECT ROUTER FROM POWER
SUPPLY WHILE ASSEMBLING PARTS
2. Attach the guide bushing directly to the
inside of the sub-base as shown In Figs. 17,
18,19. DO NOT remove the sub-base from
your muter to attach the guide bushing.
3. Secure the guide bushing to the sub-base
with the 3 screws supplied (#10-32 x 5/8 flat
head). Shown in Fig. 16. BE SURE the collar
section of your guide bushing is turned
facing away from the router motor. (See Figs.
17, 18, 19)
4. Open the base clamp lever to release and
lower the router motor in router base untilthe
collet nut is approximately 1/8-Inch clear of
guide bushing.
5. After making adjustment, re-clamp the motor.
6. Insert router bit through guide bushing and
into collar at least 1/2-inch, Fig. 19.
7. Tighten collst nut securely.
8. Visually center the cutter with the inside
diameter of the guide bushing. NOTE:
Adjustments can be made by loosening
the screws holding the sub-base to the
router,
9. Tighten all screws securely. WARNING:
FAILURE TO CENTER CUTTER WITH
BUSHINGS OR FAILURE TO FIRMLY
TIGHTEN SCREWS AFTER CENTERING
COULD CAUSE THE CUTTER TO COME
IN CONTACT WITH THE GUIDE
BUSHING,
RESULTING
IN POSSIBLE
SERIOUS INJURY.
WARNING;
_LWAYS WEAR SAFETY
GLASSE_ _i
EYE SHIELDS
WHEN
OPERATIN_
YOUR POWER TOOL.
O_ERATION
1. Place your router, with guide bushing
attached, a_!_St
template. The template
will serve as it guide and restrict the
movement of your router within the
desired area being cut.
2. Grasp your mUter and hold It firmly with
both hands.
3. Turn router on and let the motor build to
its full speed_
4. Gradually feed the cutter into workpiece.
WARNING:
KEEP A FIRM GRIP ON
ROUTER WITH BOTH HANDS AT ALL
TIMES.
FAILLE
TO DO SO COULD
RESULT IN_S$
OF CONTROL
LEADING TO! POSSIBLE
SERIOUS
INJURY.
5. Upon completion
of out, turn motor off
and let it come to a complete stop before
removing router from work surface.
The following _€ommended
templates
are available at your nearest Sears
Full-Line Retail Store or at
www.craftsrnan;.com on the internet.
Butt Hinge Ts_!ates
Dovetail Templtte
Box Joint Template
Letter and Si_
Making Template Set
Replacement _ettar Template Set
See the table _
for proper selection
of bushings, cutters and templates
BUSHING
PILOT 0.0.
5/16-1n.
5/8-in.
7116-in.
5/1 6-1n,
5t8-1n,
BUSHING, CUTTERAND TEMPLATETABLE
I i
GUTTERDIA
1/4 INCH
1/2 INCH
1/2 INCH
114INCH
1/2 INCH
TYPE.
TEMPLATE
DOVETAIL
BIT
DOVETAIL
STRAIGHT BIT
BUTT HINGE
DOVETAIL BIT
DOVETAIL
SmA,G oct BoXJOl
STRAIGHT BIT
BOX JOINT
-18-
Hide quick links:
Advertisement
Table of Contents
