Assembly; Assembly Of Column And Table Hardware; Installing The Table - Craftsman 113.213853 Owner's Manual

assembly
WARNING: For your own safety, never connect
plug to power source outlet until all assembly steps
are completed.
ASSEMBLY OF COLUMN AND TABLE HARDWARE
1. Position base on floor. Remove protective covering
and discard.
2. Remove protective sleeve from column tube and
discard. Place column assembly on base, and align
holes in column support with holes in base.
3. Locate four (4) 3/8-16xl 1/2 bolts and four (4) 3/8
Iockwashers among loose parts bag.
4. Install a Iockwasher and bolt in each hole through
column support and base, and tighten with adjusta-
ble wrench.
COLUMN I
s
5. Locate table crank assembly, support lock, and
wrench among loose parts.
6. Install table crank assembly and tighten set screw
with 1/8" HEX "L" wrench.
COLUMN
TABLE
SUPPORT
TABLE
SUPPORT
7. Install support lock from left side into table support
and tighten by hand.
8. Handle should turn freely when raising or lowering
table, if adjustment is needed, loosen jam nut, with
a screwdriver loosen bolt handle until there is play
between jam nut and handle. Tighten jam nut se-
curely while holding bolt handle with screwdriver.
SUPPORT
LOCK
TABLE
CRANK
JAM NUT
HANDLE
9. Position column collar over rack and tighten set
screw in collar, with 1/8" HEX "L" wrench. Collar
should not be angled on the column. Only tighten
set screw enough to keep collar in place; rack should
still slide freely in collar.
CAUTION: To avoid column or collar damage,
do not overtighten set screw.
COLUMN
COLLAR
COLUMN
RACK
INSTALLING THE TABLE
1. Loosen support lock and raise table support by turn-
ing table crank clockwise until support is at a working
height level. Tighten support lock.
COLI
TABLE
SUPP_
SUPPORT
LOCK
RACK
7