Attaching The Router To The Table; Cutting Height Adjustment Holes - Craftsman 320.37599 Operator's Manual

ATTACHING THE ROUTER TO
THE TABLE
Attach the router to the router
table after you have assembled
the table.
1. Unplug the router.
2. Place the router table upright,
with the front edge closest
to you.
3. Be sure that the table is stable
and that it rests on both legs.
4. Remove the base plate from
the router and hold the router
upside down (Fig. 6). If your
router model is listed in Table
2, determine the hole pattern
that matches the mounting
hole pattern for your router, as
shown in Table 2 and Fig. 5.
Table 2
Cutting height adjustment holes
Fig. 5
A "'IV° O_
Fig. 6
c .,.._o
A
Brand Above-the-table height Model
adjustment Hole
Craftsman
Craftsman
Craftsman
C
D
28084
27680
27669
27666
27683
17541
17542
37595
2767
17543
28190
28084
27680
2768
27683
(using the plunge base)
(using the plunge base)
(using the plunge base)
(using the fixed base)
(using the fixed base)
(using the fixed base)
(using the fixed base)
37599 Manual_Revised_12 1219 Page 15