Removing Motor From Base; Installing Motor In Bases - Craftsman 130.26620 Operator's Manual

REMOVING MOTOR FROM BASE
Toremove motor from fixed base: (Fig, 5)
1.Hold r outer inhorizontal
peslUon, open base
clamp lever, depress coarse adjustment
lever, and pull motor upwards until it stops.
2. Turn motor counter-clockwise, and gently
pull it free of base.
To remove motor from plunge base: (Fig. 6)
1. Hold muter in horizontal position, open base
clamp lever, and pull motor upwards until it
stops.
2. Turn motor counter-clockwise, and gently
pull it free of base.
INSTALLING MOTOR IN BASE8
The motor can be Installed with the switch
positioned on the right or left of the base from
the operator's side (and the cord facing the
opposite side of the muter). Install the motor so
that the switch is in the location you find to be
the most easily accessible _'om the handles.
The switch should be easier to turn "OFF" than
"ON" in case of an emergency.
To install motor in fixed base."
1, Release the base clamp lever.
2. Une up the arrow on the base with arrow on
the motor. (Fig. 7)
• To position switch on the right side of the
base, line up the base's arrow with motor
houelng's arrow that is below the cord.
• To position switch on the left, line up the
base's arrow with motor heusing's arrow
that is below the switch.
3. While pressing the coarse adjustment lever,
slide motor into base until raslstance in felt.
(The base's guide pin is nOw engaged into
slot on motor.)
4. Continue to press coarse ;adjustment lever,
and turn the motor clockwise until it stops.
5. Push the motor into the base until it reaches
the approximate desired depth.
6. Release the coarse adjustment lever and
slide the motor forward or back as needed
until the coarse adjustment syBtem's "catch"
springs into the coarse adjustment detent
notch.
7. Set final height position as described in
"Operating Instructions".
ALIGNMENT
ARROWS
-10-
LEVER
BASE
iCLAMP
LEVER
i
ii
!ii
BASE
BASE
if!
COARSE
ADJUS[MENT
NOTCHES
I