Advertisement
_
CAUTION:Useofcontrols or adjustments or per-
formance ofprocedures o therthanthosespecified
herein mayresult i nhazardous r adiation exposure.
ADJUSTINGTHE LASER
See Figures 16- 18.
[] Remove battery pack from the drill.
[] Facing a wall, center the bubble in the top level.
[] Clamp the drill in a vice or other clamp so that the laser
lines will project onto a wall.
NOTE: For accurate measurements, do not exceed a
3 ft. distance from the nearest wall. Otherwise, laser
lines may not intersect properly for perpendicular
mea-
surements.
[] Place battery pack in the drill.
[] Turn on the laser.
_1_ WARNING:
DO NOT point the laser at yourself
or others. Class Ilia lasers will burn the retinas and
could cause serious injury to the eyes.
MAKING
VERTICAL
LASER LINE ADJUSTMENTS
See Figure 16.
[] The front screw moves the laser line, changing the
angle. Turn the screw clockwise to angle the top edge
of the laser line to the left. Counterclockwise
will angle
the laser line to the right.
[] The rear screw moves the laser line right to left. Turn-
ing the screw clockwise moves the laser line right.
Counterclockwise
moves the laser line left along the
horizontal axis.
[] Use a level and a framing square to take measure-
ments of the laser lines on the wall to determine what
adjustments
are needed.
NOTE: Use a level to check the horizontal and vertical
laser lines. A framing square or level can be used to check
if the laser lines are perpendicular. The laser lines should
project a 90 ° angle.
Make adjustments
with the drill clamped in place and the
lasers facing away from the user.
----q
REAR
HEXKEY
SCREW
FRONTSCREW
Fig. 17
MAKING
HORIZONTAL
LASER
LINE
ADJUSTMENTS
See Figure 17.
[] The front screw rotates the laser line to change the
angle. Turn the screw clockwise to angle the right edge
of the laser line up. Turn the screw counterclockwise
to
angle the laser line down.
[] The rear screw moves the laser line up and down.
Turning the screw clockwise moves the laser line
down. Counterclockwise
moves the laser line up the
vertical axis.
FRONT
SCREW
\
(
REAR
SCREW
HEXKEY
Fig. 16
18
315,115440
Fig. 18
Advertisement
