Advertisement
USING
THE LASER GUIDE
See Figure 12.
,_
WARNING:
To avoid possible injury, do not stare
into the laser beam. The laser unit comes from the
factory already installed and aligned, but if the laser
becomes misaligned after time, refer to the Adjust-
ments section.
[] Aim the drill toward a wall.
[] Depress the laser switch. The drill will project two lines
in a 90 ° right angle on the wall.
[] Using the levels to keep laser lines level, project the
laser lines on the wall.
USING
THE AUXILIARY
HANDLE
ASSEMBLY
See Figure 13.
Your drill is equipped with an auxiliary handle assembly.
For ease of operation, use the handle with either the left or
right hand. The handle can be rotated 360 °.
To adjust the auxiliary handle assembly:
[] Loosen the handle assembly by turning the handle
counterclockwise.
[] Rotate the handle assembly to the desired operating
position.
[] Securely tighten by turning the handle assembly
clockwise.
NOTE: For convenience and ease of starting threads, the
hex nut has been trapped inside the molded slot in the
handle assembly.
LASER
SWITCH
AUXILIARY
HANDLEASSEMBLY
GROOVE
Fig. 12
TO
TIGHTEN
LOOSEN
360°
ROTATION
Fig. 13
16
Advertisement
