Carrier 33CS450-01 Owner's Manual page 75

lnternet/Phone
Control of the
Programmabb Output
To operate a MISC output using Internet/phone-based operation,
program advanced setup step #30 for Aux (below). This terminal is
especially useful for devices that can be energized via the Internet.
Telephone control may also be available when the thermostat is
connected to the Internet.
Possible REMOTE scenarios:
1) Arm the alarm system in your building after you have left for
the day.
2) Turn offyour sign lights after arriving home.
3) Turn on your interior lights while you're closed.
Press the UP button three
times to set the
programmable output
for Aux (web-based
operation)
r_oD_ _ Press the MODE button. While holding
Note: Press the
MODE
the MODE, press the PROGRAM button momentarily
pROGRAM _J button to enterSetup screens.
to
move
through the
setup screens. Press
and hold the MODE
Press the MODE button repeatedly but'on to move back-
MOBE . . waras tnrough the
MeOE (J until this setup screen appears. "_ setup screens.
C OFF _Time = le:eS_Temp = 88"-- Aux _._ _*_
Pross
NODE @
Programmable Output Polarity: _*_A_ ._ ._?_*; _ f _@
NC = Normally Closed to operate Z_
when programmed to be OFF
through the ph ..... ntemet. W NW K
I IU
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds
Page 14.7