Setting a Thermastat Jumper
Praocrammable O utput Operation
To control one of the MISC outputs using time, temperature, or
Internet/phone
based operation, place the MISC1, or MISC2, or
MISC3 jumper on the terminal labeled PR©G (see diagram below).
This extra output will supply 24VAC to the selected MISC terminal
based on the programming described in the following pages, ©nly
one of the three outputs (MISC1, MISC2, or MISC3) is required to
have this jumper. For more information regarding the MlSC!, MlSC2,
and MlSC3 outputs, please see section 2!.
In the diagram below, the MISC1jumper has
been set for PROG
operation.
_\Y2
(MISCl
MlSCl
ONLY)
MISTS
OK
IMPORTANT
CAUTION
NEVER PUT MORE THAN ONE JUMPER
ON THE SAME
MISC JUMPER
BLOCK!
THIS MAY DAMAGE
THE THERMOSTAT
AND
VOID YOUR WARRANTY
Page 14.2