Installing
the Humidity
Modub
To install the Humidity Module the thermostat must be detached
from the back plate. Plug the Humidity Module into the Humidity
Module connector as shown in Figure 2 below. Follow the detailed
instructions included with the Humidity Module accessory.
Once the
Humidity Module has been installed, you must adjust the Humidity
jumper setting to HUM as shown in Figure 1 below. This will allow
you to access the humidification and dehumidification
setup steps.
For proper humidity
operation,
this
jumper
must be set for HUM.
Back of 33CS450-01
BBBBB" °
Figure 1
_]
UM
OR
NO HUM
Figure
2
Install the Humidity
Module
see Humidity
Module
Instruction
_heet
for more detailed
information).
---....
Humidity Module
t
/
the Thermostat
Page 9.2