Advertisement
Available languages
Available languages
No water
Nozzle is
coming out
clogged
of nozzle
Spray Gun
Trigger will
NOT Move
Unit will
NOT start
NOTE: Unit will
only start and
run when trigger
is depressed
and water is
spraying!
Motor stops
working during
normal operation
NOTE: Motor's
thermal overload
switch tripping
because
the motor is
overheated
Allow the motor
to cool for 20
minutes before
troubleshooting
and the switch
will automatically
reset.
Water inlet
filter screen
is clogged
Kink in the
garden hose
or hose is
wrapped on a
storage wheel
Gun safety lock
is engaged
Unit is not
turned ON
GFCI Plug is
not reset
Extension cord
is too long or
wire gauge
is too small
Nozzle is
clogged
Defective
Spray Gun
Clean the nozzle according to the instructions
_rovided
in the
Nozzle
paragraph
under
Maintenance section of this manual.
Remove the filter screen (O) from the water
inlet (M) and clean it thoroughly. Replace the
filter screen.
Use a maximum
garden
hose length
of
50 ft. (15.2 m) (city water) or 25 ft. (7.5 m)
(well water). Ensure the garden hose is laid
out flat and does not have any kinks or
leaks. Unwrap
garden hose from
reel or
hook (if applicable). Replace garden hose if
necessary.
Release safety lock according to instructions
3rovided in the Starting
paragraph
under
Operation in this manual.
Verify
that the On/Off
Switch
(I) is fully
engaged in the ON position.
Confirm the GFCI plug is reset and functioning
according to instructions provided in Ground-
Fault
Circuit
Interrupter
Protection
paragraph under Power Supply & Electrical
info in this manual.
We do not recommend the use of extension
cords
with your
pressure
washer.
If you
must use an extension
cord, verify that it
meets the minimum requirements listed in the
Extension Cord paragraph under the Power
Supply & Electrical Info in this manual.
Clean the nozzle according to the instructions
3rovided
in the
Nozzle
paragraph
under
Maintenance section of this manual.
Turn unit OFF, disconnect
incoming water
from unit, and remove the gun and hose
assembly. Aim pressure washer away from
the electrical outlet, reconnect incoming
water, and switch the unit into the ON
3osition. If the motor starts and water flows
steadily out of the front (and you have
verified that the nozzle is not clogged), the
spray gun may be malfunctioning
and need
to be replaced. Please contact our customer
service department
at www.power-washer.
us or by calling 1-800-381-0999.
19-ENG
Advertisement
