Black & Decker 11BLE-325 Instruction Manual page 15

Model 11BLE-325
PSI Max* 1900 psi
GPM Max* 1.5 gpm
Electrical Requirements 120V,
15 A, 60 Hz
Electrical Cord 35 ft. (10.6 m)
High Pressure Hose 25 ft. (7.6 m)
Minimum Amp Source 15A
Presure of Inlet Water 20-100 psi
Inlet Water cold tap
Soap Consumption Rate 10% max
* Water flow and maximum pressure
ratings determined in accordance
with PWMA standard PW101.
Do not return this product to your
retailer. Please contact our customer
service department at www.power-
washer.us or 1-800-381-0999.
Limited Warranty
This product is warranted against
defects in material and workmanship for
a period of one year on all components
excluding the spray gun, high pressure
hose, lances, nozzles, and ground fault
circuit interrupter (GFCI) which are only
covered for 90 days; effective from
the date of retail purchase and is not
transferable.
This warranty excludes incidental/
consequential damages and failures
due to misuse, abuse or normal wear
and tear. This warranty applies only
to products used in consumer (home)
applications.
This warranty does not apply to
commercial or rental applications.
This warranty gives you specific rights,
and you may also have other rights,
which vary from state to state.
Please complete and return the
enclosed Customer Information Card.
Return of this card is not required to
validate this warranty. A store issued
receipt or credit card statement showing
the purchase date is an acceptable
warranty validation. Please retain one of
these documents in your records.
If you have any questions, please
contact our customer service
department at www.power-washer.us
or 1-800-381-0999.
What is covered: Replacement parts
and labor. Please note that we reserve
the right to repair or replace the product
as we deem appropriate.
What is not covered: This warranty
does not include such parts as
nozzles which must be replaced as
part of normal maintenance of the
equipment, rather than as the result
of a defect. Transportation charges to
warranty center for defective products.
Transportation charges to consumer for
repaired products. Damages caused
by abuse, accident, improper repair, or
failure to perform normal maintenance.
Use of improper chemicals or
noncompliance with the operator
manual's instructions. Sales outside
of the United States or Canada. Any
other expense including consequential
damages, incidental damages, or
incidental expenses, including damage
to property. Some states do not allow
the exclusion or limitation of incidental
or consequential damages, so the
above limitation or exclusion may not
apply to you. This warranty does not
cover damage resulting from failure to
observe any of the following conditions:
1) The inlet water pressure must be
between 20 and 100 p.s.i.
2) The inlet water temperature must
not exceed 90°F (32°C).
3) The unit should not be stored in
areas where temperatures may
drop below 40 ° F (4° C).
15-ENG