Advertisement
Available languages
Available languages
8.
Squeeze the trigger to start motor
and begin pressure washing.
NOTE: The motor only runs when
the gun trigger is depressed
and
water is spraying.
SHUTTING
DOWN
See Storage
section
in this
manual
for
proper
shutdown
and
storage
procedures.
Z_ WARNING:
Risk of burn hazard.
When performing
maintenance,
you
may
be exposed
to hot surfaces,
water pressure or moving parts that
can cause serious injury or death.
To ensure efficient operation and longer
life of your pressure washer, a routine
maintenance
schedule
should
be
prepared and followed, if the pressure
washer is used in unusual conditions,
such as high-temperatures
or dusty
conditions, more frequent maintenance
checks will be required.
CONNECTIONS
Connections on pressure washer hoses,
gun and spray wand should be cleaned
regularly and lubricated with light oil or
lithium grease to prevent leakage and
damage to the o-rings.
NOZZLE
The adjustable spray nozzle should be
cleaned regularly.
Clogging
of
the
nozzle
causes
diminished performance and the pump
pressure to be too high and cleaning is
immediately required.
1.
Remove the wand from the gun.
2.
Clear the nozzle by forcing a stiff
wire or straightened out paper clip
(small size) through the center hole
of each nozzle.
3.
Backflush
the nozzle with water
from both ends.
4.
Reconnect the wand to the gun.
Restart
the
pressure
washer
and
depress the trigger on the spray gun.
LU BRICATiON
The
pressure
washer
is
designed
with a permanent
lubrication
system.
Conventional
oil checks and changes
are not necessary.
NOTE: [n case of oil leakage, contact
our customer
service
department
at
www.power-washer.us
or 1-800-381-
0999.
A SMALL
AMOUNT
OF OIL
LEAKAGE IS NORMAL.
WATER SCREEN FILTER
The pressure washer is equipped with
a water
inlet screen filter to protect
the pump. Never operate the pressure
washer without the screen filter in place.
Z_ CAUTION:
[f the screen filter is
not kept clean, the flow of water to the
pressure washer will be restricted and
the pump may be damaged.
•
To clean the inlet water screen filter,
remove garden hose connector (D)
and remove the screen filter from
the inlet.
Flush screen filter with warm water
to clean.
Replace screen filter, and garden
hose
connector
immediately
to
prevent
any foreign
matter from
entering the pump.
CAUTION:
Do not damage the
screen filter, while removing or cleaning.
Any foreign particles entering the pump
may damage the pump.
COOLING SYSTEM
The air vents, located in and around the
pressure washer, must be kept clean
and free of any obstructions
to ensure
proper air cooling of the motor during
operation.
Z_ WARNING:
Prevent
water
from
penetrating
the vents of the pressure
washer to minimize the risk of damage
to the machine and to reduce the risk of
shock to the operator.
13-ENG
Advertisement
