Download Print this page

Black & Decker 11BLE-325 Instruction Manual page 7

Advertisement

Available languages

Available languages

A.
Inspect cord before using. Do not
use if cord is damaged.
B.
Keep all connections
dry and off
the ground.
C.
Do not touch plug with wet hands.
D.
The pressure washer is provided
with a ground fault circuit interrupter
built into the power plug.
If replacement
of the plug or cord is
needed, use only identical replacement
parts. Contact
customer
service
for
proper replacement parts.
,4X WARNING: Test GFCI before each
use. DO NOT use pressure washer if
test below fails.
GFCI Test Procedures:
1.
Plug GFCI into power receptacle.
Indicator light should illuminate.
2.
Press test button (Z). Light should
turn off.
3.
Press reset button
(Y) for
use.
Indicator light should illuminate.
O
EXTENSION CORDS
Use only extension
cords
that
are
intended
for
outdoor
use.
These
extension
cords
are identified
by a
marking
"Acceptable
for
use
with
outdoor
appliances:
store
indoors
while not in use". Use only extension
cords
having
an electrical
rating not
less than the rating of the product.
Do not use damaged extension cords.
Examine extension
cord before using
and replace if damaged.
Do not abuse
extension cord and do not yank on any
cord to disconnect.
Keep
cord
away
from
heat
and
sharp edges. Always
disconnect
the
extension
cord
from
the receptacle
before disconnecting
the product from
the extension cord.
When using an extension cord, observe
the specification
below:
Cable Length
Wire Gauge
Up to 25 ft.
12 AWG Outdoor
(7.5 m)
Z_ WARNING:
To reduce the risk of
electrocution,
keep all connections
dry
and off the ground. Do not touch plug
with wet hands.
SAVE THESE
iNSTRUCTiONS
Do not use if above test fails.
NOTE: The GFC[ must be reset each
time the pressure washer is connected
to an electrical outlet. Reset by simply
pushing the reset button on the GFC[
power plug.
7- ENG

Advertisement

loading