Advertisement
Available languages
Available languages
2.
Remove the tank cap (W) present
on the back of the machine.
3.
Fill
the
tank
(J) with
suitable
cleaning solution.
4.
Place
the Click-N-Clean _*_spray
lance into the Low Pressure Soap
position (S, fig. 4).
5.
Squeeze
the
trigger
and
the
detergent
will
automatically
be mixed
with
the
water
and
dispensed from the nozzle.
NOTE:
When
the
Click-N-Clean
_
nozzle is moved to the High Pressure
Medium
or High Pressure Wide Fan
Spray position, detergent
will not be
dispensed.
6.
When you have
completed
the
use of detergent, Fill and flush the
detergent
tank with
clear water
after use. See Storage for correct
procedure.
7.
See Storage section in this manual
for proper shutdown
and storage
procedures
Cleaning
techniques
When cleaning with the pressure washer,
some cleaning tasks can be solved with
water alone, but for most tasks it is
advantageous
to use a detergent.
A
detergent ensures a quick soaking of
the dirt allowing the high pressure water
to penetrate and remove the dirt more
effectively.
Application
of detergent
z_ CAUTION:
Avoid working
on hot
surfaces or in direct sunlight
to mini-
mize the chance of the soap damaging
painted surfaces.
/tk CAUTION:
Damage may occur to
painted surface if soap is allowed to dry
on the surface. Wash and rinse a small
section at a time.
1.
Apply the solution to a DRY work
surface.
NOTE: WETTING THE SURFACE
FIRST IS NOT RECOMMENDED,
AS IT DILUTES THE DETERGENT
AND REDUCES
ITS CLEANING
ABILITY.
On a vertical surface, apply soap
horizontally
from
side
to
side
starting from the bottom to avoid
streaking.
2.
Allow detergent to remain on the
surface
for a short time
before
rinsing.
3.
Rinse with clean water under high
pressure.
On a vertical
surface,
first rinse from the bottom up, then
rinse from
the top down.
Hold
nozzle 6-8 in. (15-20 cm) from the
work surface at a 45 ° angle using
the flat spray
as a peeling tool
rather than a scrub brush.
NOTE:
Ensure
that
the
detergent
injection
system
is completely
clean
prior to switching
from one detergent
to another.
STARTING
(FIG. 8=14)
DANGER: Risk of injury from spray.
Always engage the trigger lock when
gun is not in use. Failure to do so could
cause accidental spraying.
,4k WARNING:
Risk of Injury. Do not
direct discharge stream at self or others.
Z_ WARNING: Risk of unsafe operation.
Stand on a stable surface and grip gun/
spray wand firmly with both hands.
11- ENG
Advertisement
