General
Regular periodic maintenance on your
Model W1752 will ensure its optimum performance. Make
a habit of inspecting your machine each time you use it.
Check for the following conditions and repair or
replace when necessary:
Daily Check:
•
Loose mounting bolts.
•
Worn or damaged wires.
•
Worn switch
•
Any other unsafe condition.
Monthly Check:
•
Belt tension, damage, or wear.
•
Clean/vacuum dust buildup off of motor.
Cleaning
Cleaning the Model W1752 is relatively easy. Vacuum excess
wood chips and sawdust, and wipe off the remaining dust
with a dry cloth. If any resin has built up, use a resin dis-
solving cleaner to remove it.
Unpainted Cast Iron
Protect the unpainted cast iron surfaces on the lathe by
wiping them clean after every use—this ensures moisture
from wood dust does not remain on bare metal surfaces.
Keep the bed rust-free with regular applications of quality
metal protectant products.
Changing Belt
To change the belt, do these steps:
1. Perform Steps 1-2 in the Changing Speeds proce-
dure on Page 16.
2. Roll the belt off of the pulleys and slide it under the
belt cover plates.
3. Reverse Steps 1-2 to reinstall the belt.
MAINTENANCE
SHOP FOX
®
-26-
W1752 Owner's Manual (Mfg. 1/07+)
MAKE SURE that your machine is
unplugged during all maintenance pro-
cedures! If this warning is ignored, seri-
ous personal injury may occur.
Lubrication
Lubricate the locations shown in Figure 26
with light machine oil.
Figure 26. Lubrication locations.