Epson Stylus Color II Reference Manual page 49

All lights except the Power light flash and nothing prints.
Contact your dealer or your Authorized EPSON servicer.
Printing stops and the Data and Pause lights flash.
There is a problem with the carriage. Turn off the printer. After
a few seconds, turn it back on and try printing again. If this
does not solve the problem, contact your dealer or an
authorized EPSON servicer.
You see a system memory error message on your PC and
the printer does not print.
The Copies options in the Windows printer driver require
additional system memory. If you see an error message or are
unable to print using these options, try closing any unnecessary
applications, reducing the size of your print job, turning off the
Copies options, or increasing system memory.
The Windows printer driver installed with Windows 3.1 does
not work correctly after you upgrade to Windows 95.
You need to reinstall the printer driver after upgrading to
Windows 95 so the driver is set up correctly for Windows 95.
See the Setup and Software Guide for Windows for instructions.
The printer sounds like it is printing, but nothing prints.
The print heads may need cleaning. See "Cleaning the Print
Heads" in Chapter 3 for instructions.
One or both ink cartridges are empty or too old. A cartridge is
too old if it has been used longer than six months or beyond the
date on its packaging. First clean the print heads as described
earlier in this chapter. If this does not solve the problem,
replace the ink cartridges.
4-8
Troubleshooting