Note: Since the quality of any particular brand or type of paper may be changed by the manufacturer at any time, EPSON cannot guarantee the use of any particular brand or type of paper. Always test samples of paper stock before purchasing large quantities or printing large jobs.
(High-quality glossy paper can be stored at 20 to 60% relative humidity.) Do not load curled or folded paper, envelopes, or transparencies. The following EPSON genuine papers are available: Special coated paper for 360 dpi printing (Letter) Special coated paper for 720 dpi printing (Letter)
** The ink thaws and is usable after approximately 3 hours at 77°F (25°C). Caution: Use only genuine EPSON cartridges and do not refill or dismantle them. Other products may cause damage to your printer not covered by EPSON’s warranties.
Data transfer must be carried out by observing the ACKNLG or following cases: BUSY signal. Data transfer to this printer can be carried out 1) During data entry only after receipt of the ACKNLG signal or when the level of the...
Initialization The printer can be initialized (returned to a fixed set of conditions) in these ways: Hardware The printer is turned on. initialization The printer receives an INIT signal from the parallel interface: pin 31 goes LOW. Software Software sends the ESC @ (initialize the initialization printer) command.
Pause button and then turn off the printer. Checks the paper length and performs a Load/Eject + POWER printer self test at 360 dpi. To stop the self switch test, press the Pause button and then turn off the printer.
Composite black is a mixture of the inks in the color ink cartridge and closely resembles black ink. When you first set up the printer, you need to charge its ink delivery system by installing first the color ink cartridge and then replacing it with the black print head unit and cartridge.
1. Make sure the printer is on and the printer cover is open. 2. Press the Pause button until the Pause light comes on. 3. Hold down the Alt button for about five seconds until the print head unit moves left slightly to the ink cartridge install position.
Do not lift up the ink cartridge clamp; the ink cartridge and print head may become unusable. 5. Grasp both sides of the print head unit and carefully lift it out of the printer. Place the print head unit on a flat, clean surface. Caution: Do not touch the electrical contacts on the back and bottom of the print head unit or inside the printer;...
Reusing a cartridge that has been removed may damage the print head. Use only genuine EPSON ink cartridges and do not refill them. Other products may cause damage to your printer that is not covered by EPSON’s warranties.
C:\ directory \CALIBRAT if it is on your hard disk). Then press Enter. 5. When you see the Calibration Utility screen, make sure Stylus COLOR IIs is selected as the printer. If it isn’t, use to select it. Also make sure Print Calibration Pattern is selected at the bottom of the screen.
30 sheets of EPSON high-quality glossy paper with a sheet of plain paper beneath the last sheet in the stack. To avoid printing on the plain paper, print your document one page at a time.
Use a higher quality paper that is suitable for ink jet printers and is not too thin, too thick, or rough. For best quality, use EPSON special coated and high-quality glossy papers. Fan the stack of paper before you load it.
Black ink cartridge S020047 Color ink cartridge S020049 Caution: Use only genuine EPSON cartridges and do not refill them. Other products may cause damage to your printer that is not covered by EPSON’s warranties. Removing and Installing an Ink Cartridge Follow these steps to replace an ink cartridge: 1.
Do not discard the print head unit. Use only genuine EPSON ink cartridges and do not refill them. Other products may cause damage to your printer that is not covered by EPSON’s warranties.