Epson Stylus Color II Reference Manual page 30

Interface mode. Determines from which interface the
printer receives print data. The default setting, Auto, allows
the printer to automatically switch as needed between the
parallel and serial interfaces. However, if you experience
communication problems, you might want to set the
interface mode to either Parallel or Serial.
Auto interface wait time. Sets the time period for the
printer to wait for data from the current interface (and
accept no data from the other interface) when you're using
the Auto interface mode. You can select a 10-second
(default) or 30-second timeout.
Software. Specifies the printer control language to use:
EPSON ESC/P 2 (default) or IBM X24/X24E. If your
software allows you to select EPSON ESC/P 2, choose it for
the most advanced fonts and graphics.
Auto CR. Specifies that the printer perform a carriage
return and line feed operation if the print positions exceed
the right margin of the paper. (Used in IBM X24/X24E
mode only.)
AGM (Alternate Graphics Mode). Specifies that the printer
use high-resolution, 24-pin graphics commands. (Used in
IBM X24/X24E mode only.)
Character table. Selects the set of characters and symbols
that can be printed. The default is the Italic U.S.A. character
table. If you commonly use a language containing accents,
symbols, or other characters not available in the Italic
U.S.A. character table, change to a different character table.
For a list of the character tables, see Appendix B.
Auto line feed. Specifies that a carriage return character
encountered in the print file be accompanied by a line feed
command. By default, auto line feed is off. If text lines print
on top of one another, turn on auto line feed.
2-8
Controlling the Printer