Table of Contents
Advertisement
SAFETY T]PS
I
PAGE
3
These simple precautions will help ensure that you get many years of safe enjoyment from your new product.
1.
2,
Read Instructions
Read all of the safety and operating instructions before
operaUng the product.
Retain ZnstrncUons
Keep all safety and operating instructions for future
reference.
11. Power Sources
Operate product only from type of power source
indicated on marking Label. If you are not sure of the
type of power supply to your home, consult your
product dealer or Local power company. For products
intended to operate flora battery power or other
sources, refer to manual.
3.
Heed Warnings
FoLLow warnings on the product and in the opemUng
guide.
4.
FoLLow I nstructions
FoLLow artopemUng anduseinstructions.
5. CLeaning
Unplugthis product from the wall outlet before
cleaning.Donot useLiquid cleaners or aerosol c leaners.
Usea dampcloth for cleaning,
6.
Attachments
Donot use attachments not recommended b y product
manufacturer asthey may causehazards.
7.
Water and Moisture
Do not use this product near water--for example, near
a bathtub, wash bowl, sink, or Laundrytub, in a wet
basement, or near a swimming pool.
12.
13.
Line-Cord Polarization
Product is equipped with a polarized alternating-
current Une plug (a plug having one bLadewider than
the other). As a safety feature, this plug wilt fit into
power outlet only one way. If you're unable to insert
plug fully into outlet, try reversing the plug. If plug
still fails to fit, contact an electrician to repLace your
obsolete outlet. Do not defeat safety purpose of
polarized plug.
Power-Cord Protection
Route power-supply cords so
they are not Ukeiy to be
walked on or pinched by items
placed upon or against them,
paying particular attention to
cords at plugs, convenience
receptacles, and the point
whqre they exit from product.
8.
Accessodes
Do not place product on an unstable cart, stand,
tripod, bracket, or table. Product may fat[+ causing
serious injury to a chltd or adult, and serious damage
to the product. Use only with a cart, stand, tripod,
bracket, or table recommended by the manufacturer or
sold with the product. Any mounting of product should
follow manufacturer's instructions and should use a
mounting accessory recommendedby manufacturer+
9.
Transporting Product
Move product and cart combinations
with care. Quick stops, excessive
force, and uneven surfaces may cause
product and cart combination to
overturn.
®
10. Ventilation
Slots and openings in cabinet must not be blocked or
covered. They are provided for ventiLation, to ensure
reliable operation, and to protect from overheating.
Never block openings by placing product on a bed,
sofa, rug, or other simiLar sun'ace. Do not place product
in bui[t-ln installation
such as a bookcase or rack
unless proper ventilation
is provided or manufacturer's
instructions
have been adhered to.
14. Outdoor Antenna Grounding
If an outside antenna or cable system is connected to
this product, be sure antenna or cable system is
grounded so as to provide some protection against
voltage surgesand built-up static charges. A_c[e 810
of the National ELectricalCode (USA), ANSI/NFPA 70
provides information
on grounding of mast and
supporting structure, grounding of Lead-in wife to an
antenna discharge unit connection to grounding
electrodes, and requirementsfor grounding electrode.
( See Fig. 1 below. )
Fig. 1
+
_
Antenna Lead-ln Wire
Ground
Clamp
Antenna Discharge Unit
NECSection 810-20
•
•
Grounding Conductors
ELectricSer_ce
NECSection 810-?1
Equipment
Ground Clamps
__m,
OUnding
NECArtZSO, Part H
NEC: National ELectrical C ode
Antennagrounding per NEC Code,ANSI/NFPA 70
Advertisement
Table of Contents
