JVC GZ-MG155U Instructions Manual page 52

Troubleshooting (Continued)
®Adjust the brightness and angle of the LCD monitor. 48
®When the LCD monitor's LED light reaches the end of
its service life, images on the LCD monitor become dark.
Consult your nearest JVC dealer.
®The LCD monitor is made with high precision technology.
However, black spots or bright spots of light (red, green
or blue) may appear constantly on the LCD monitor.
These spots are not recorded on the picture. This is not
due to any defect of the unit.
(Effective dots: more than 99.99 %)
® Change the settings in [SELECT TV TYPE] so that it 49
matches the screen size of the connected TV.
® Recording medium is full. Delete unnecessary files or 30
replace the SD card.
• Select the recording medium properly. 47, 48
• Such a phenomenon occurs when shooting a subject
illuminated by bright light. This is not a malfunction.
® Such a phenomenon occurs when shooting under direct
sunlight. This is not a malfunction.
• Set [DATE/TIME] to [ON]. 49
®The temperature of the camera is increasing. If the
camera continues to heat up, recording may be stopped
to protect the recording medium. In this case turn off the
power, and then wait until the camera cools down.
® Certain modes of program AE, effect, DIS, and other
functions that cannot be used together are selected at
the same time.
® Change the settings in [ZOOM]. 46
• Digital zoom is not available in the still image recording
mode.
• Set focus to the automatic mode. 22
• Clean the lens and check the focus again. 55
• Try manual white balance adjustment. 23
® In bright places, setting "Nightalive" or a slow speed is
not recommended.
®When the recorded image is too dark, try backlight 21,22
compensation or adjust brightness.
®When the recorded image is too bright, try adjust 22
brightness.
52