JVC GZ-MG155U Instructions Manual page 4

Read This First!
Make a backup of important recorded data
JVC will not be responsible for any lost data. It is recommended to copy your important
recorded data to a DVD or other recording media for storage. (_ pg. 40)
Make a trial recording
Before the actual recording of important data, make a trial recording and play back the
recorded data to check that the video and sound have been recorded correctly.
Reset the camera if it does not operate correctly
This camera uses a microcomputer. Factors such as background noise and interference
can prevent it from operating correctly. If the camera does not operate correctly, reset
the camera.(_ pg.51)
Precautions on handling batteries
® Be sure to use the JVC BN-VF808U/VF815U/VF823U battery packs.
• If the camera is subjected to electrostatic discharge, turn the power off before using it
again.
if a malfunction occurs, stop using the camera immediately
and consult your local JVC dealer
• If a problem occurs when using tile SD card, take tile card together with the camera
for repair. If one of them is not included, the cause of the malfunction cannot be
diagnosed, and the camera cannot be repaired.
® Recorded data may be erased while the camera is being repaired or inspected. Back
up all data before requesting repairs or inspections.
Because the camera may be used for demonstration in a
shop, the demonstration mode is set to on by default
To deactivate tile demonstration mode, set [DEMO MODE] to [OFF]. (_ pg. 48)
This operating instruction is applicable to models
GZ-MG255, GZ-MG155 and GZ-MG130
® Unless otherwise indicated, illustrations in this operating instructions are of
GZ-MG130.
• Icons such as _ indicate that the feature is applicable to the specified model only.
When connecting the camera to other device
using a DV cable, make sure to follow the procedure below.
Connecting the cable incorrectly may cause malfunctions to
the camera and/or other device.
® Connect the DV cable first to other device, and then to the camera.
® Connect the DV cable (plugs) correctly according to the shape of the DV connector.