Safety/Operations - Windsor TRIDENT COMPACT TCZOE Operating Instructions Manual

EXTENSION CORDS:
If an extension cord is used, the wire size must be at least one
size larger than the power cord on the machine, and the cord
must be a type SJTW/SSTW:A.
HOW IT OPERATES
The TRIDENT COMPACT is a walk-behind scrubber.
The main scrubbing components include a solutiodrecovery
tank, single disc-type brush or pad, a rear squeegee and a vac-
uum motor.
Detergent solution and water flow from the solution
the scrub brush. The rotating brush scrubs the floor. As the
machine moves forward, the rear squeegee collects the dirty
solution and channels it into the vacuum of the squeegee pickup
hose. The pickup hose deposits the dirty solution into the re-
covery tank.
PREPARING FOR OPERATION
(PERFORM DAILY MAINTENANCE AS SHOWN ON
PAGE 7.)
Fill Solution Tank
Remove cover and fill. (see item 19, page
1.)
Use a clean bucket or hose to fill the tank
2.)
with water.
3.) Add a cleaning concentrate for use in automatic floor
scrubbers. Closely follow the manufacturer's instructions
found on container. Read ingredients listed on the container
to ensure compatible chemicals are used.
Use only the suitable chemicals listed below. Using incom-
patible chemicals may damage the machine. Damages of
this type are not covered under the WINDSOR Three Year
Protection Plan. Carefully read ingredients on manufac-
turer's label before using any product in this machine.
I
SUITABLE
CHEMICALS
Alkalis
Detergents
Hydroxides
tank
14)
INCOMPATIBLE
CHEMICALS
Aldehydes
Carbon Tetrachloride
Chlorinated Hydrocarbons
Methyls (MEK)
Phenols
Trichlorethylene
D-Limonene
PREPARING FOR OPERA TION(Cont..)
4.) Plug the power cords together and twist into locked
position. Attatch the power cord to the yellow strain
relief as shown. Plug power cord into a properly
grounded wall outlet.
5.) Turn vacuum motor switch on and
there is electrical power at machine.
OPERATING THE MACHINE
(PERFORM DAILYMAINTENANCEAS SHOWN ON
PAGE 7.)
1 . Adjust the operator control handle to a
to
comfortable position. (see item 3, page 6)
2. Switch on main power switch. (see item 1, page 5)
3. Release solution. (Pull solution control lever
rearward.) (see item 6, page
amount of solution can be regulated during
operation depending on the type of floor and the
traverse speed of the machine. Pulling the lever
farther rearward releases more solution.
4. Switch on brush drive motor. (see item 1, page 6)
5. Switch on vacuum motor. (see item 2, page 6)
6. Lower scrub deck. Pull scrub deck lift lever
rearward. (see item 8, page 6)
is stationary.
7. Lower squeegee. Pull squeegee lift lever
back. (see item
squeegee as shown on page 9.
Move machine forward bv aDDlvinrr even
8.
pressure on the main haidle
assisted by the scrubbing action of the brushlpad
driver.
I
Take extra care not to run machine over cord or
catch cord on squeegee when turning.
7. Plan your cleaning route to work away from the
electrical source. Move machine forward at a
steady pace
off to make sure
NOTE: The
6)
page NOTE: Adjust
7, 6)
.
Forward motion is
5