Adf Unit Removal - Lexmark X500n Service Manual

6. Repeat steps 3, 4, and 5 for the other arm, if needed.
Note: If you are replacing the scanner arm, remove the spring from the old scanner arm. The spring will go
on the new arm.

ADF unit removal

1. Remove the upper left rear cover. See
2. Remove the left rear cover. See
3. Remove the system board cover.
4. Remove the screw (B) that secures the ADF, and flatbed ground wires to the RIP cage.
5. Disconnect the ADF cable from the system board.
"Upper left rear cover removal" on page
"Left rear cover removal" on page
B
4-17.
4-16.
Repair information
7100-XXX
4-53