Page 1
Manual to replace the CPU-fan of the Lexmark x502n Attention: This manual refers exclusively to the altered fan distributed by ProCompSys! Standard-models of this fan can not be operated with the Lexmark x502n in this manner! Note: Arbitrary modification on your device may void the manufacturer's...
Page 2
7. Attach the new fan back to the two 8. Due to variation in production on behalf spacers that remained on the of Lexmark, it is not possible to equip circuit board using the two the replacement-fan with a plug fitting remaining screws.
Page 3
either a) cut off the existing plug 9. The white plastic jack is glued to the from the defective fan and connect/ circuit board and can be loosened quite solder it to the replacement-fan easily using p. ex. a pair of long-nosed (pay attention to the polarity: pliers.
Page 4
10. The replacement-fan's plug can now easily be connected to the contact pins on the circuit board. Pay attention to the correct polarity (red wire to the left)! ("Red wire to the left " also applies if you did not have to remove the white plastic jack from the circuit-board!) The color-sequence of the...