Toner Sensor (Receiver) Removal; Left Tray Guide Assembly Removal - Lexmark X500n Service Manual

7100-XXX

Toner sensor (receiver) removal

Note: The toner sensor is comprised of two separate parts: the sender and the receiver. The sender
portion of the toner sensor is located on the right side of the MFP. See
on page 4-24 for removal.
1. Remove the HVPS cage. See
2. Remove 2 screws (A); remove the toner sensor (receiver).
3. Disconnect the toner sensor cable from the connector (B) on the toner sensor (receiver).
Note: The bottom screw is longer than the top screw.

Left tray guide assembly removal

1. Remove the marker sensor. See
2. Remove the HVPS cage. See
3. Reroute cable (A) to allow sufficient cable length for removing the left tray guide assembly from the
frame.
4. Remove two (B) screws that secure the left tray guide assembly to the MFP frame.
4-42
Service Manual
"HVPS cage removal" on page
B
"Marker sensor assembly removal" on page
"HVPS cage removal" on page
A
"Toner sensor (sender) removal"
4-41.
A
4-41.
B
4-46.