Kyocera TASKalfa 255 Operation Manual page 252

Setup, Registration, and User Management > System Menu
Item
Sleep Level
(Detailed settings)
Auto Error Clear
Low Power Timer
Panel Reset Timer
Sleep Timer
Interrupt Clear Timer
Error Clear Timer
Select the Sleep level.
Detailed settings for sleep mode are called Energy Saver mode. When a function is set in
Energy Saver mode, the machine will not wake from sleep mode even if print data is received
from a computer connected with a USB cable.
Example: When print data is sent from a PC connected by USB
Quick Recovery: When the machine receives print data, it wakes from sleep mode and starts
printing.
Energy Saver: The machine does not wake from sleep mode when it receives print data and
printing does not take place.
Value: Quick Recovery, Energy Saver
NOTE: If the optional Gigabit Ethernet Board is installed, Energy Saver cannot be
specified.
Set the conditions for waking from sleep mode when the Energy Saver function is selected.
Set whether to wake from sleep mode when the machine receives data by means of the
following functions:
Network
USB Cable
Card Reader
RAM Disk
FAX
Value
Off: Do not wake from sleep mode, even if data is received.
On: Wake from sleep mode when data is received.
If an error occurs during processing, processing stops to wait for the next step to be taken by
the user. In the Auto Error Clear mode, automatically clear the error after a set amount of time
elapses. For details, refer to Responding to Error Messages on page 10-12.
Value: Off, On
Set the Low Power Mode delay.
Value: 1 to 240 minutes (1 minute increments).
If you select [On] for Auto Panel Reset, set the amount of time to wait before Auto Panel Reset.
Value: 5 to 495 seconds (every five seconds)
NOTE: If you select [Off] for Auto Panel Reset, the time display does not appear.
Set the Sleep Mode delay.
Value: 1 to 240 minutes (1 minute increments)
NOTE: If you select [Off] for Auto Sleep, the time display does not appear.
Set the period after which the machine reverts to Normal mode when it has been set to
Interrupt Copy mode and then left unused.
Value: 5 to 495 seconds (every five seconds)
If you select [On] for Auto Error Clear, set the amount of time to wait before automatically
clearing errors.
Value: 5 to 495 seconds (every five seconds)
NOTE: If you select [Off] for Auto Error Clear, the time display does not appear.
9-22
Description