Error Messages - Kyocera TASKalfa 205c Operation Manual

Troubleshooting > Error Messages

Error Messages

When an error occurs, the display may show one of the error messages listed below. These will help you identify and
correct the problem.
NOTE
When a transmission error occurs, a sent/receipt result report is produced.
Check the error code shown in the report and refer to Error Code List on page 10-6 for a description. To print the sent/
receipt result report, refer to Send Result Reports on page 8-4 and FAX RX Result Reports on page 8-6.
You may also check error codes using the activity report. (Refer to Activity Report on page 8-7.)
Message
Machine failure.
Box limit exceeded.
Job Accounting restriction
exceeded.
Restricted by Job Accounting.
Cannot print.
The phone receiver is off the
hook.
Scheduled sending jobs
exceeded.
Checkpoint
―
―
―
―
Is the phone (commercially
available) connected to the
machine off the hook?
―
10-4
Corrective Action
Turn the main power switch off and on, or
unplug the power cord and plug it in
again. If the message still appears, note
the error code. Turn the main power
switch off and unplug the power cord. Call
your service representative.
• Sub Address Box capacity is used up
with document data. Press [End]. The
job is canceled. Try to perform the job
again after printing or deleting the data
in the Sub Address Box.
• The polling box is full. Press [End]. The
job will be canceled. Delete documents
from the polling box and then repeat
the operation.
The number of paper used has exceeded
the limit preset by Job Accounting.
No further operation is possible. Press
[End]. The job is canceled.
Try to perform the job again after resetting
the limit for paper use.
Fax transmission is prohibited by Job
Accounting. No further operation is
possible. Press [End]. The job is
canceled.
Check the setting for Job Accounting.
Hang up the handset.
The number of jobs has exceeded the
limit set for delayed transmission. Press
[End]. The job is canceled.
Wait until the delayed transmission is
executed, or cancel the delayed
transmission and then perform the job
again.
Reference
Page
―
6-13
Refer to the
machine's
Operation
Guide.
Refer to the
machine's
Operation
Guide.
―
4-16