Resetting The Network Configuration In Maintenance Mode (Option 2); Resetting User Accounts In Maintenance Mode (Option 3); Copying Log Files In Maintenance Mode (Option 4); Removing The Switch Configuration In Maintenance Mode (Option 5) - HP StorageWorks SN6000 Installation And Reference Manual

Resetting the network configuration in maintenance mode (option 2)

The Reset Network Config option resets the network properties to the factory default values and saves them
on the switch. For default network configuration values, see

Resetting user accounts in maintenance mode (option 3)

The Reset User Accounts to Default option restores the password for the Admin account name to the default
(password) and removes all other user accounts from the switch.

Copying log files in maintenance mode (option 4)

The Copy Log Files option copies all log file buffers to a file on the switch named logfile. You can use
FTP to download this file to the workstation, however, you must download logfile before resetting the
switch. For information about downloading files from the switch, see the HP StorageWorks SN6000 Fibre
Channel Switch Command Line Interface Guide.

Removing the switch configuration in maintenance mode (option 5)

The Remove Switch Config option deletes all configurations from the switch except the default
configuration. This restores switch configuration parameters to the factory defaults. See
Configuration

Remaking the file system in maintenance mode (option 6)

The Remake Filesystem option resets the switch to the factory default values, including user accounts and
zoning. Use this option to recreate the file system when the switch configuration becomes corrupt because
of a loss of power. See
NOTE: If you choose the Remake Filesystem option, you will lose all changes made to the fabric
configuration that involve that switch, such as password and zoning changes. You must then restore the
switch from an archived configuration or reconfigure the portions of the fabric that involve the switch.

Resetting the switch in maintenance mode (option 7)

The Reset Switch option closes the Telnet session, exits maintenance mode, and reboots the switch using
the current switch configuration. All unpacked firmware image files that reside on the switch are deleted.

Updating the boot loader in maintenance mode (option 8)

The Update Boot Loader option updates the system boot loader which loads the Linux kernel into memory.
Use this option only at the direction of your authorized maintenance provider.
Defaults" (page 79) for the factory default values.
"Factory Configuration
HP StorageWorks SN6000 Fibre Channel Switch Installation and Reference Guide
"Factory Configuration
Defaults" (page 79) for the factory default values.
Defaults" (page 79).
"Factory
59