Unpacking A Firmware Image File In Maintenance Mode (Option 1); Resetting The Network Configuration In Maintenance Mode (Option 2); Resetting User Accounts In Maintenance Mode (Option 3); Copying Log Files In Maintenance Mode (Option 4) - HP StorageWorks 8/20q Installation And Reference Manual

Unpacking a firmware image file in maintenance mode (option 1)

The Image Unpack option unpacks and installs new firmware when the current firmware has become
corrupt. Before using this option, you must load the new firmware image file onto the switch. To install new
firmware using this option:
1. Place the switch in maintenance mode. See the procedure for maintenance mode in
switch using maintenance
2. Use FTP to load a new firmware image file onto the switch. See
(page 43) for an example of how to load the image file. When the download is complete, close the
FTP session.
3. Establish a Telnet session with the switch using the default IP address 10.0.0.1.
telnet 10.0.0.1
4. Enter the maintenance mode account name (prom) and password (prom), and press Enter.
Switch login: prom
Password: xxxx
5. Select option 1 from the maintenance menu. When prompted for a file name, enter the firmware image
file name:
Image filename: filename
Unpacking 'filename', please wait...
Unpackage successful.
6. Select option 7, Reset Switch, to reset the switch and exit maintenance mode.

Resetting the network configuration in maintenance mode (option 2)

The Reset Network Config option resets the network properties to the factory default values and saves them
on the switch. For default network configuration values, see

Resetting user accounts in maintenance mode (option 3)

The Reset User Accounts to Default option restores the password for the Admin account name to the default
(password) and removes all other user accounts from the switch.

Copying log files in maintenance mode (option 4)

The Copy Log Files option copies all log file buffers to a file on the switch named logfile. You can use
FTP to download this file to the workstation, however, you must download logfile before resetting the
switch. For information about downloading files from the switch, see the HP StorageWorks 8/20q Fibre
Channel Switch Command Line Interface Guide.

Removing the switch configuration in maintenance mode (option 5)

The Remove Switch Config option deletes all configurations from the switch except the default
configuration. This restores switch configuration parameters to the factory defaults. See
Configuration

Remaking the file system in maintenance mode (option 6)

The Remake Filesystem option resets the switch to the factory default values, including user accounts and
zoning. Use this option to recreate the file system when the switch configuration becomes corrupt because
of a loss of power. See
NOTE: If you choose the Remake Filesystem option, you will lose all changes made to the fabric
configuration that involve that switch, such as password and zoning changes. You must then restore the
switch from an archived configuration or reconfigure the portions of the fabric that involve the switch.
56
mode" (page 55).
Defaults" (page 73) for the factory default values.
"Factory Configuration
"Custom firmware
"Factory Configuration
Defaults" (page 73) for the factory default values.
"Recovering a
installation"
Defaults" (page 73).
"Factory